Earls Male AN - Tee to 1/ ″ NPT on Branch. Earls -AN Male to ″ Tubing Adapter. Air Inlet Adapter -to-Blower Bolts -20 . Plug, pipe, 1⁄4-(rqr) Plug, pipe, ⁄4-(rqr) Stu - x 13⁄in. Fuel line (rqr) Fuel adapter (rqr) Flat washer (spec) (rqr) Push.
Solder fittings of sight glass (para -13). Remove valve (fig 6- 16. Fusible Plug a. General. The fusible plug ( , fig. 6- ) is located on top of. INDEX (Cont'd) INDEX (Cont'd) ----- ---25.
Disconnect the flare fitting and plug the tube flare fitting. Bending l2-8b 12- Flaring 12-8a 12-Fabrication, fuel line : Bending. Rocker arm cover -17i -Spark plug and adapter -17c. Society of Automotive Engineers.
Handbook, Section — Units, Parts, and Fittings , S. Recommended Practice for Serrated Shaft . Tighten screws (18) to to pound-feet (to Nm) and screws (60) to 13. Install elbow (4) on pump (7), install hose fitting ( ) in elbow (4), and. Position wiring harness (43) on pump (7) and secure with two washers.
Install two clamps (9) on fuel line under support (14), install clamp (24) on air hose ( ), . Remove the four lockwasher screws and nuts from the 90-degree elbow adapter (L, fig Drill the three -inch holes and secure inlet hood to panel with three 1/4-x external (2) Connect the heater-to-filter fuel line from the outlet of the heater fuel filter. Pipe, Tubing, Hose Fittings.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.